IFS Hub spacers for Solid Axles (WTB)

Joined: 22 Oct 2002 Location: Your Mummas House!

I want some, soon, where can I buy them???

Who has the best price?
What is the $$?

Are these in stock, or will I be waiting around ages? Do the kist fit perfectly?

Posted: Sat Aug 02, 2003 1:03 pm

i got mine from Chaos4x4. i ordered them they turned up 2 days later Very Happy

good price also as everything u need is in the kit (except the hubs & bearings)

Joined: 21 Oct 2002 Location: London

hypolux wrote:

i got mine from Chaos4x4. i ordered them they turned up 2 days later Very Happy

good price also as everything u need is in the kit (except the hubs & bearings)

So did I. Good quality I have had them installed for about 2 months.

Chris

Joined: 20 Oct 2002 Location: gold coast, australia

Chaos is the place to get em.

NICK

Joined: 22 Oct 2002

How much???

Posted: Sun Aug 03, 2003 6:13 pm

POS wrote:

How much???

i think i payed 280 inc freight ill have 2 dig out my recepit(sp?) so i can b sure

Joined: 29 Jul 2003 Location: Newcastle

Ben with the chaos wide track hubs,where do you bolt the spacers , is it in the disc & hub, or is it behind the stub axle Question

What do you need off the IFS hubs, did these cost much Question

I'll ring your mob tomorrow after work [daywork] cause I wanna see yah bout some parts Idea

Rob

Posted: Sun Aug 03, 2003 10:12 pm

Old Yella wrote:

Ben with the chaos wide track hubs,where do you bolt the spacers , is it in the disc & hub, or is it behind the stub axle Question

What do you need off the IFS hubs, did these cost much Question

I'll ring your mob tomorrow after work [daywork] cause I wanna see yah bout some parts Idea

Rob

the spacer bolts onto the back of the hub and then the standard solid front disk bolts 2 the spacer so that the disk runs in the same spot as normal.

the only bit needed from the ifs is the wheel hub itself u dont wanna use the ifs rotors coz u dont get as much pad - disk contact

Joined: 29 Jul 2003 Location: Newcastle

Cool thanks Ben Very Happy

Rob

Joined: 22 Oct 2002 Location: Your Mummas House!

I talked to Richard from 4x4 engineering and he said he would do them so that i could bolt them on for $450 a pair. A bit exxy at the moment.

$280 for both sideds hypo?

anyone know if it is just the studs that line up the rotor? If so that is apparently bad as toyota have it so the rotor and hub are press fit. The press fit allows for less movement. Any thoughts? I am just curious!

Posted: Mon Aug 04, 2003 7:57 am

when i had mine made, i had them made press fit and also the rotor bolted
to the spacer

Posted: Mon Aug 04, 2003 12:14 pm

bj on roids wrote:

$280 for both sideds hypo?

yes mate ill have 2 fine my receipt 2 b sure but it wasnt any more than 300 a pair

Joined: 08 Nov 2002 Location: Sydney

currently listed on the chaos site for $365