Quick dual case question

Joined: 20 Oct 2002 Location: Greenbank, Qld

what is the exact dimension between the centres of where the stock rubber mounts are on the t-case and the crawler box on a dual case setup

Joined: 31 Jul 2003 Location: cinti, ohio, USA

6.5 inches rings a bell, will know this weekend for sure, am installing another one.

Joined: 22 Oct 2002

I can tell you that when you put dual cases in you need to shorten the rear shaft by 165mm ( and vice versa for the front).

Posted: Wed Dec 10, 2003 4:36 pm

o working on mine this arvo so ill measure up and get some pix and get back 2 u later 2nite

Joined: 20 Oct 2002 Location: Greenbank, Qld

hypolux wrote:

o working on mine this arvo so ill measure up and get some pix and get back 2 u later 2nite

well?

Posted: Sun Dec 14, 2003 8:34 pm

Joined: 20 Oct 2002 Location: Greenbank, Qld

anyone

Joined: 22 Oct 2002

POS wrote:

I can tell you that when you put dual cases in you need to shorten the rear shaft by 165mm ( and vice versa for the front).

Can you not WORK it out using this measurement??????

Joined: 20 Oct 2002 Location: Greenbank, Qld

sorry about the other reply Embarassed

i have reserched on pirate and a few other places and it says 6.5" which equals 165.1mm

so i hope if i make it to this it should fit

Joined: 08 Nov 2002 Location: sunshine coast

so how long do u think untill these will be ready, i will test it for you Laughing

Joined: 08 Oct 2003 Location: Denver, CO, US

6½" exactly. That's what mine is.

Joined: 20 Oct 2002 Location: Greenbank, Qld

toy283 wrote:

6½" exactly. That's what mine is.

thanks