Outer Limits 4x4 Board Forum Index

 FAQFAQ   SearchSearch   MemberlistMemberlist        RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
View next topic
View previous topic

Post new topic   Reply to topic  Outer Limits 4x4 Board Forum Index » Nissan
Author Message
LOCKEE



Joined: 14 Apr 2004
Location: Melbourne, looking at the hills for snow

PostPosted: Fri Jul 11, 2008 12:08 pm Reply with quote Back to top

I would like to add keyless entry to my GQ. Ay one had experience with adding in a eBay Kit to the factory central lockng?

_________________
LOCKEE wrote:
**********
BOGGED wrote:
I hate u...
View user's profile Send private message Send e-mail
BowTieGQ



Joined: 16 Feb 2005
Location: Acting the goat.

PostPosted: Fri Jul 11, 2008 8:19 pm Reply with quote Back to top

Lockee, I removed the wires into my doors, pink ones, and started fresh. The factory setup is crap. There is no solinoid/actuator/motor in the drivers' door. It is merely a switch that is activated by the key to lock the other doors. So it must be locked/unlocked via the key every time. I have always used the crappy $20 central locking kits from Strathfield without problems. If one gives up, I buy a new kit and have spares for next time. Not that I have problems either. You will need two kits to get a 5th actuator for the rear door. Then I wire it all up to an aftermarket alarm. Works fine and easy.

_________________
bazooked wrote:
can i use a mate to position while i screw? Twisted Evil
View user's profile Send private message
fastest



Joined: 04 Jun 2004
Location: Melbourne Western Suburbs

PostPosted: Fri Jul 11, 2008 9:25 pm Reply with quote Back to top

I did the same as BowtieGQ and i have not had any problems in 3 years, i put the control box behind the battery.

_________________
Don't Follow Me... I'm Lost Too...........
View user's profile Send private message
its aford not a nissan



Joined: 25 Sep 2006
Location: carina hts

PostPosted: Fri Jul 11, 2008 10:00 pm Reply with quote Back to top

being a ti it probly already has solinoids for all the doors bar the drivers door , so you just need one actuator for it , then you could hook up your keyless entry to it only and control all the other doors


easier and less wiring to do Very Happy
View user's profile Send private message
BowTieGQ



Joined: 16 Feb 2005
Location: Acting the goat.

PostPosted: Sat Jul 12, 2008 8:33 am Reply with quote Back to top

True. But the Nissan ones are prone to breaking at the arm that pivots. I also changed it all so that I knew it was compatable with the alarm I was instaling at the same time.

_________________
bazooked wrote:
can i use a mate to position while i screw? Twisted Evil
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic


Go to OuterLimits4x4
View next topic
View previous topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB :: Theme & Graphics by Daz
Protected by Anti-Spam ACP
All times are GMT + 10 Hours